2012 Toyota Matrix FWD L4-1.8L (2ZR-FE)FACTORY OEM SERVICE PROCEDURE

Removal





2ZR-FE ENGINE CONTROL: IGNITION COIL AND SPARK PLUG: REMOVAL

1. REMOVE NO. 2 CYLINDER HEAD COVER Removal

2. REMOVE IGNITION COIL ASSEMBLY

(a) Disconnect the 4 ignition coil connectors.

Factory service manual diagram




(b) Remove the 4 bolts and 4 ignition coils.

Factory service manual diagram




NOTICE:
When removing each ignition coil, do not damage the plug cap on the engine head cover opening or the upper edge of the spark plug tube.

3. REMOVE SPARK PLUG

(a) Using a 14 mm spark plug wrench, remove the 4 spark plugs.

Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.