2012 Toyota Matrix FWD L4-1.8L (2ZR-FE)FACTORY OEM SERVICE PROCEDURE

Removal





2ZR-FE ENGINE CONTROL: KNOCK SENSOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT Service and Repair

3. REMOVE NO. 2 CYLINDER HEAD COVER Removal

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE Removal

5. REMOVE INTAKE MANIFOLD

(a) Disconnect the throttle body connector and the 2 water by-pass hoses.

Factory service manual diagram




(b) Separate the wire harness clamp and remove the bolt and wire harness bracket.

Factory service manual diagram




(c) Separate the 2 hoses.

Factory service manual diagram




(d) Separate the ventilation hose.

Factory service manual diagram




(e) Separate the 2 wire harness clamps.

Factory service manual diagram




(f) Separate the 2 wire harness clamps.

Factory service manual diagram




(g) Remove the 4 bolts and 2 nuts and remove the intake manifold stay and intake manifold with throttle body.

Factory service manual diagram




(h) Remove the gasket from the intake manifold.

Factory service manual diagram




6. REMOVE KNOCK SENSOR

(a) Disconnect the knock sensor connector.

Factory service manual diagram




(b) Remove the bolt and remove the knock sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.