2012 Toyota Matrix Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Fail-Safe Chart

WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.

HINT:Β 

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition Auto Cancel Condition Re-operation Condition
Cruise main indicator light blinks
  • There is an open or a short in the stop light switch circuit
  • There is a problem with the vehicle speed signal
Turn the cruise control main switch on again
Cruise main indicator light goes off
  • There is a problem with the throttle position sensor and motor
Turn the cruise control main switch on again
Cruise main indicator light blinks
  • There is a problem with the input circuit of the stop light switch circuit
  • There is a problem with the cancel circuit
  • Turn the cruise control main switch on again
  • Turn the ignition switch off then ON again
Cruise main indicator light remains on (Cruise control is canceled) Under the following conditions, the stored vehicle speed is maintained:
  • The Vehicle speed is lower than the low speed limit (approx. 40 km/h (25 mph)) while running with the cruise control on
  • The VSC system is operated
Push the cruise control main switch to + (ACCEL)/RES (RESUME)
  • The Vehicle speed is lower than the stored speed by approx. 16 km/h (10 mph) or more
Push the cruise control main switch to - (COAST)/SET
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.