2012 Toyota Matrix AWD L4-2.4L (2AZ-FE)FACTORY OEM SERVICE PROCEDURE

Removal





2AZ-FE ENGINE CONTROL: KNOCK SENSOR: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE

(a) Discharge fuel system pressure Service Precautions.

2. DRAIN COOLANT Service and Repair

3. REMOVE FRONT WIPER ARM HEAD CAP Removal

4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

6. REMOVE HOOD TO COWL TOP SEAL Removal

7. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

8. REMOVE COWL TOP VENTILATOR LOUVER LH Removal

9. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal

10. REMOVE OUTER COWL TOP PANEL Removal

11. REMOVE SUSPENSION TOWER DAMPER ASSEMBLY (w/ Front Strut Bar) Removal

12. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Removal

13. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE Removal

14. REMOVE THROTTLE BODY ASSEMBLY Removal

15. DISCONNECT FUEL TUBE SUB-ASSEMBLY Removal

16. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY WITH FUEL TUBE SUB-ASSEMBLY Removal

17. REMOVE INTAKE MANIFOLD

Factory service manual diagram




(a) Disconnect the ventilation hose.

(b) Disconnect the union to check valve hose.

Factory service manual diagram




(c) Separate the wire harness clamp from the intake manifold.

Factory service manual diagram




(d) Remove the 5 bolts, 2 nuts and intake manifold.

(e) Remove the intake manifold gasket.

Factory service manual diagram




18. REMOVE NO. 1 INTAKE MANIFOLD INSULATOR

(a) Remove the No. 1 intake manifold insulator.

19. REMOVE KNOCK SENSOR

Factory service manual diagram




(a) Disconnect the sensor connector.

(b) Remove the nut and knock sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.