2012 Toyota FJ Cruiser 4WD, Part Time T/Case ControlFACTORY OEM SERVICE PROCEDURE

Repair Instruction: Initialization: Initialization

  • The initialization procedures are below the table.
System Name
Meter / Gauge System
  1. DESCRIPTION 
    NOTE:

    Do not place magnetic or metal objects on or near the accessory meter.

    HINT: 

    The procedures described below are for vehicles equipped with an accessory meter.

    1. The location of magnetic north differs depending on the vehicle location. Adjustment of the compass' magnetism is required to correct possible compass deviations from true north.
    2. Compass function calibration is necessary when: 1) purchasing a vehicle; 2) disconnecting and reconnecting the cable of the negative (-) battery terminal; 3) replacing the vehicle battery; 4) driving the vehicle outside the set zone (see the zone map ); or 5) placing magnetic or metal objects near the accessory meter (the direction indication on the display blinks).
  2. PERFORM CALIBRATION 
    WARNING:
    • Strictly observe posted speed limits, traffic laws and road conditions.
    • Make sure no people are near the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.