2012 Toyota 4Runner TrailFACTORY OEM SERVICE PROCEDURE

Service Data

FUEL PRESSURE

at idle 321 to 327 kPa
(3.27 to 3.33 kgf/cm2 , 46.5 to 47.4 psi)
remains for 5 minutes after engine has stopped 147 kPa
(1.5 kgf/cm2 , 21 psi) or higher
FUEL INJECTOR

Resistance: at 20Β°C (68Β°F) 11.6 to 12.4 Ξ©
Injection volume 71 to 86 cm3 (4.3 to 5.2 cu in.) per 15 seconds
Difference between each cylinder 15 cm3 (0.9 cu in.) or less
Fuel leakage 1 drop or less per 12 minutes
FUEL PUMP

Tester Connection Condition Specified Condition
1 - 2 20Β°C (68Β°F) 0.2 to 3.0 Ξ©
FUEL SENDER GAUGE

Tester Connection Condition Specified Condition
2 - 3 Float level is F (upper) 12 to 18 Ξ©
Float level is E (lower) 405 to 415 Ξ©
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.