2012 Toyota 4Runner Limited, AWDFACTORY OEM SERVICE PROCEDURE

DTC P060D: Internal Control Module Accelerator Pedal Position Performance: Procedure

  1. CHECK FOR DTC 
    1. Clear DTCs. Refer to DTC CHECK / CLEAR .
    2. Turn the ignition switch off.
    3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
    4. Connect the cable to the negative (-) battery terminal.
    5. Turn the ignition switch to ON.
    6. Check for DTCs.

      OK

      P060D is not output.

    NG → See step   3 

    OK → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS 
  3. REPLACE ECM. Refer to  REMOVAL 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.