Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fail-Safe Chart
If a problem occurs in the power steering system, the P/S warning light will come on in the combination meter and power steering assist will be stopped, fixed at a particular point, or decreased simultaneously to protect the system.
| DTC No. | Malfunction | Fail-safe |
|---|---|---|
| C1511 | Torque sensor malfunction | Power assist stops |
| C1512 | ||
| C1513 | ||
| C1514 | ||
| C1515 | ||
| C1516 | ||
| C1517 | ||
| C1521 | Motor circuit malfunction | |
| C1522 | ||
| C1523 | ||
| C1524 | ||
| C1525 | Motor rotation angle sensor malfunction | |
| C1526 | ||
| C1528 | ||
| C1531 | ECU malfunction | |
| C1532 | ||
| C1533 | Assist force restricted | |
| C1534 | ||
| C1541 | Skid control malfunction | Amount of power assist is locked at 100 km/h (62 mph) level |
| C1551 | IG power source voltage error | Power assist stops |
| C1552 | PIG power source voltage error | |
| C1554 | Power source relay malfunction | |
| C1555 | Motor relay malfunction | |
| C1581 | ECU malfunction | |
| U0100 | ECM communication malfunction | |
| U0129 | Skid control ECU communication error | Amount of power assist is locked at 100 km/h (62 mph) level |
HINT:Β
The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
