Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Technical Service Bulletins
- A/C Compressor
- Accessories & Equipment
- Accessories Control Systems
- Air Bag, SRS
- Anti-Theft Systems
- Automatic Trans
- Auxiliary Emission Control Systems
- Body Electrical
- Brakes Control Systems
- Charging Systems
- Cooling System (Mechanical)
- Engine Control Systems
- GTS+ Ecu Flash Reprogramming Procedure (T-SB-0134-16 REV2)
- Extended Crank At High Altitude With High Temperatures (T-SB-0069-11 REV2)
- Mil "On" P043E, P043F, P2401, P2402, & P2419 Due To Water Intrusion Into Charcoal Canister (T-SB-0200-11 REV1)
- Momentary Rpm Decrease Above 40 Mph And/Or Reduced Engine Braking (T-SB-0124-11)
- Exterior Body Panels
- Corrosion Prevention For Collision Repair - Crib # 186 (S-CRIB-186)
- Approved Collision Repair Methods - Crib # 176 (S-CRIB-176)
- Use Of Genuine Parts - Crib # 180 (S-CRIB-180 REV2)
- Front/Rear Door Outer Panel Installation Substitution - Crib # 199 (S-CRIB-199)
- GMAW/Mig Welding Specifications - Crib # 196 (T-CRIB-196)
- Welded Outer Panel Replacement - Crib # 194 (T-CRIB-194)
- Frame Repair & Component Replacement - Crib # 193 (T-CRIB-193)
- PAINTLESS Dent Repair - Crib # 146 (T-CRIB-146)
- Sealing Hem-Flanges & Body Seams - Crib # 163 (T-CRIB-163)
- Frames, Subframes & Crossmembers
- Use Of Genuine Parts - Crib # 180 (S-CRIB-180 REV2)
- GMAW/Mig Welding Specifications - Crib # 196 (T-CRIB-196)
- Welded Outer Panel Replacement - Crib # 194 (T-CRIB-194)
- Frame Repair & Component Replacement - Crib # 193 (T-CRIB-193)
- Sealing Hem-Flanges & Body Seams - Crib # 163 (T-CRIB-163)
- 2011 Matrix Pre-Delivery Service (PDS) (T-SB-0347-10)
- Front License Plate & Mounting Bracket Installation (T-SB-0341-10)
- Front Suspension
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing
- Hazardous Waste Material
- HVAC Control Systems
- Identification
- Replacement Certification Labels And VIN Plates (T-SB-0032-20 REV2)
- Replacement VIN Plates (PG005-97)
- Remanufactured Automatic Transmission Serial Number Location (TC013-06)
- Automatic Transmission Serial Number Location (TC012-06)
- Ca/Fed/50 State Certified Emission Control UNDERHOOD Labels (T-SB-0054-13)
- Infotainment
- Interior/Exterior Trim
- Prevention And Repair Of Acid Rain Damage (T-SB-091-020)
- Odor Remediation Process (Dealer Performed) (T-SB-0055-24 REV1)
- SUNVISOR - Removal & Installation Procedures (T-SB-0093-09 REV2)
- Drivers Front Seat Feels Loose (T-SB-0039-11 REV1)
- Floor Mat Installation During PDS (T-SB-0086-10 REV1)
- 2011 Matrix Pre-Delivery Service (PDS) (T-SB-0347-10)
- Front License Plate & Mounting Bracket Installation (T-SB-0341-10)
- Floor Mat Installation During PDS (T-SB-0024-09 REV,)
- Lubrication System
- Mechanical
- Mechanical - Hydraulic
- Mirrors
- Paint & Coatings
- New Vehicle Washing Schedule For Paint Protection (T-SB-0039-24 REV2)
- Prevention And Repair Of Acid Rain Damage (T-SB-091-020)
- RAPGARD Protective Film Removal (T-SB-0061-23 REV2)
- Iron Particle Rust Contamination Repair (TS-PA005-04)
- Corrosion Prevention For Collision Repair - Crib # 186 (S-CRIB-186)
- Paint Stains Under RAPGARD (T-SB-0012-21 REV2)
- Clear Coat Application - Crib # 65 (T-CRIB-65)
- PAINTLESS Dent Repair - Crib # 146 (T-CRIB-146)
- Chip Resistant Coatings - Crib # 141 (L-CRIB-141)
- Long Term Vehicle Storage Guidelines (T-SB-0079-09 REV1)
- Passive Restraints
- Procedures
- Rear Suspension
- Restraints Control Systems
- Seats
- Starter
- Steering Linkage
- Suspension Control Systems
- System
- Extended Crank At High Altitude With High Temperatures (T-SB-0069-11 REV2)
- Mil "On" P043E, P043F, P2401, P2402, & P2419 Due To Water Intrusion Into Charcoal Canister (T-SB-0200-11 REV1)
- Mil "On" P0717 Due To Rodent Damage (2ZR-FE/U341E) (T-SB-0180-11)
- Momentary Rpm Decrease Above 40 Mph And/Or Reduced Engine Braking (T-SB-0124-11)
- Towing
- Transmission Control Systems
- Wheels & Tire System
- Tire Repair Resources (T-SB-0187-12 REV2)
- Flood Damaged Vehicle Inspection & Handling (T-SB-0229-12 REV1)
- 2011 Matrix Pre-Delivery Service (PDS) (T-SB-0347-10)
- Tire Pressure Warning System Initialization (T-SB-0342-10)
- Tire Positioning Before New Vehicle Delivery (T-SB-0204-10)
- Long Term Vehicle Storage Guidelines (T-SB-0079-09 REV1)
- Tire Inflation Pressure Compensation And Adjustment (T-SB-0345-08 REV2)
- Window Motors & Regulators
- Wiper/Washer Systems
- Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.