Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Brake Control: SST: SST
WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
| 09023-00101 | Union Nut Wrench 10 mm | ||
| 09520-00031 | Rear Axle Shaft Puller | ||
| (09520-00040) | Shocker | ||
| 09521-00020 | Drive Shaft Boot Clamping Tool | ||
| 09830-36010 | Front Mounting Cushion Remover & Replacer |
||
| 09843-18040 | Diagnosis Check Wire No. 2 | ||
| 09950-00020 | Bearing Remover | ||
| 09950-60010 | Replacer Set | ||
| (09951-00650) | Replacer 65 | ||
| 09950-70010 | Handle Set | ||
| (09951-07100) | Handle 100 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.