Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Installation (To 12/2010): Installation
WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL TRANSMISSION CONTROL CABLE ASSEMBLYÂ
- Put the transmission control cable assembly into the body.
- Turn over the carpet and install the transmission control cable assembly with the 2 bolts.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)Â
- Install the transmission control cable assembly to the control shaft lever with the nut.
Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)Â
- Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
- If the lock piece is engaged, slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION*1 Slider *2 Lock Piece *a Slide *b Pull NOTE:Check that the lock piece is not engaged.
- Connect the transmission control cable assembly to the transmission floor shift assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION*1 Lock Piece NOTE:- Securely engage the claws.
- Check that the lock piece is pulled up.
- Push the lock piece into the adjuster case.TEXT IN ILLUSTRATION
*1 Lock Piece *2 Adjuster Case NOTE:- Check that the park/neutral position switch and the shift lever are in neutral.
- Securely push in the lock piece until the slider lock is engaged.
- INSTALL NO. 1 AIR CLEANER INLETÂ . Refer to INSTALLATION - Step 69
- INSTALL AIR CLEANER CASEÂ . Refer to INSTALLATION - Step 70
- INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSEÂ . Refer to INSTALLATION - Step 4
- INSTALL NO. 2 AIR CLEANER INLETÂ . Refer to INSTALLATION - Step 72
- INSTALL COOL AIR INTAKE DUCT SEALÂ . Refer to INSTALLATION - Step 101
- INSTALL CENTER AIR BAG SENSOR ASSEMBLYÂ . Refer to INSTALLATION - Step 1
- INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONER UNIT ASSEMBLYÂ
Refer to INSTALLATION
- INSPECT SHIFT LEVER POSITION See step  1
- ADJUST SHIFT LEVER POSITION See step  2
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
