Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2011MATRIX AWD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCRANKSHAFT POSITION SENSORSERVICE AND REPAIRINSTALLATION
2011 Toyota Matrix AWD L4-2.4L (2AZ-FE)
Installation
2011 Toyota Matrix AWD L4-2.4L (2AZ-FE)SECTION Installation
2AZ-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
(b) Install the crankshaft position sensor with the bolt.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
Do not twist the O-ring.
(c) Install the wire harness and crankshaft position sensor connector clamp.
(d) Connect the crankshaft position sensor connector.
2. INSTALL GENERATOR ASSEMBLY Installation
3. INSTALL V-RIBBED BELT Installation
4. INSTALL ENGINE UNDER COVER RH
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT FOR OIL LEAK
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.