Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Toyota Matrix AWD L4-2.4L (2AZ-FE)FACTORY OEM SERVICE PROCEDURE
Service Data
SPECIFICATIONS: ALIGNMENT / HANDLING DIAGNOSIS: SERVICE DATA
Vehicle Height (Unloaded Vehicle)
Measuring points (for Torsion Type Suspension):
* A: Ground clearance of front wheel center
* B: Ground clearance of lower suspension arm No. 1 bush front bolt center
* C: Ground clearance of axle beam set bolt center
* D: Ground clearance of rear wheel center
Measuring points (for Double Wishbone Type Suspension):
* A: Ground clearance of front wheel center
* B: Ground clearance of lower suspension arm No. 1 bush front bolt center
* C: Ground clearance of No. 1 lower suspension arm bushing set bolt center
* D: Ground clearance of rear wheel center
Wheel Angle (Unloaded Vehicle)
Camber Inclination (Unloaded Vehicle)
Caster Inclination (Unloaded Vehicle)
Steering Axis Inclination (Unloaded Vehicle)
Toe-in (Unloaded Vehicle)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.