Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010MATRIX FWD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIRINSTALLATION
2010 Toyota Matrix FWD L4-2.4L (2AZ-FE)
Installation
2010 Toyota Matrix FWD L4-2.4L (2AZ-FE)SECTION Installation
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH
(a) Engage the pin and install the cruise control main switch as shown in the illustration.
(b) Connect the connector.
(c) Install the 2 screws.
2. INSTALL STEERING PAD Installation
3. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT STEERING PAD Installation
7. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.