Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| Back Up Light Switch (1.8L) | Left side of transaxle. See Figure. |
| Back Up Light Switch (2.4L) | Left side of transaxle. See Figure. |
| Brake Fluid Level Warning Switch (1.8L) | Brake fluid reservoir. See Figure. |
| Brake Fluid Level Warning Switch (2.4L) | Brake fluid reservoir. See Figure. |
| Clutch Start Switch | Left side of dash. See Figure. |
| Cruise Control Cancel Switch | Left side of dash. See Figure. |
| Engine Oil Pressure Switch (1.8L) | Lower left front of engine. See Figure. |
| Engine Oil Pressure Switch (2.4L) | Lower left rear of engine. See Figure. |
| Front Door Courtesy Light Switch LH | Left "B" pillar. See Figure. |
| Front Door Courtesy Light Switch RH | Right "B" pillar. See Figure. |
| Level Warning Switch (1.8L) | Washer fluid reservoir. See Figure. |
| Level Warning Switch (2.4L) | Washer fluid reservoir. See Figure. |
| Parking Brake Switch | Under center console. See Figure. |
| Park/Neutral Position Switch (1.8L) | Transaxle assembly. See Figure. |
| Park/Neutral Position Switch (2.4L) | Transaxle assembly. See Figure. |
| Rear Door Courtesy Light Switch LH | Left "C" pillar. See Figure. |
| Rear Door Courtesy Light Switch RH | Right "C" pillar. See Figure. |
| Stop Light Switch | Left side of dash. See Figure. |
| Transmission Control Switch | Under center console. See Figure. |
| Un-Lock Warning Switch | Steering column. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.