Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSTOYOTA2010MATRIX AWD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSALIGNMENTSERVICE DATA
2010 Toyota Matrix AWD L4-2.4L (2AZ-FE)
Service Data
2010 Toyota Matrix AWD L4-2.4L (2AZ-FE)SECTION Service Data
SPECIFICATIONS: ALIGNMENT / HANDLING DIAGNOSIS: SERVICE DATA
HINT
* for Mexico vehicle height, B and C points are 15 mm (0.591 in.) higher than standard vehicle.
Measuring points (for Torsion Type Suspension):
* A: Ground clearance of front wheel center
* B: Ground clearance of lower suspension arm No. 1 bush front bolt center
* C: Ground clearance of axle beam set bolt center
* D: Ground clearance of rear wheel center
Measuring points (for Double Wishbone Type Suspension):
* A: Ground clearance of front wheel center
* B: Ground clearance of lower suspension arm No. 1 bush front bolt center
* C: Ground clearance of No. 1 lower suspension arm bushing set bolt center
* D: Ground clearance of rear wheel center
Wheel Angle (Unloaded Vehicle):
Camber Inclination (Unloaded Vehicle):
Caster Inclination (Unloaded Vehicle):
Steering Axis Inclination (Unloaded Vehicle):
Toe-in (Unloaded Vehicle):
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.