WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear speed sensor.

INSTALL REAR SPEED SENSOR
1. Clean the contact surface between the rear axle hub and bearing assembly and a new rear speed sensor.
  NOTE: Prevent foreign matter from attaching to the sensor rotor.
2. Place the rear speed sensor on the rear axle hub and bearing assembly so that the connector is positioned at the bottom.
  
  Fig 1: Placing Rear Speed Sensor On Rear Axle Hub
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST, steel plates and a press, install a new speed sensor to the rear axle hub and bearing assembly.
  SST 09214-76011
  NOTE:
  - Keep the rear speed sensor away from magnets.
  - Do not use a hammer to install the rear speed sensor.
  - Check that there is no foreign matter such as iron chips on the detecting portion of the rear speed sensor.
  - Slowly press in the rear speed sensor straight.

Chapter Navigation

Return to Chapter: Rear Speed Sensor

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Rear Speed Sensor: Installation

Use the Manual With the Right Hardware

When to See a Mechanic