Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE
Steering Angle Sensor: Installation
- INSTALL STEERING ANGLE SENSORÂ
- Install the steering sensor onto the spiral cable.
- PLACE FRONT WHEELS FACING STRAIGHT AHEADÂ
- INSTALL SPIRAL CABLE SUB-ASSEMBLYÂ (See INSTALLATION )
- INSTALL STEERING COLUMN COVER LWRÂ (See INSTALLATION )
- CENTER SPIRAL CABLEÂ (See INSTALLATION )
- INSTALL STEERING WHEEL ASSEMBLYÂ
- INSPECT STEERING WHEEL CENTER POINTÂ (See INSTALLATION )
- INSTALL HORN BUTTON ASSEMBLYÂ (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINALÂ NOTE:
- Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.
- Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.
- INSPECT SRS WARNING LIGHTÂ
HINT:
See PRECAUTION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
