2009 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE

Front Speed Sensor: Removal

HINT:

Remove the RH side by same procedures with LH side.

  1. REMOVE FRONT WHEEL 
  2. REMOVE FRONT FENDER LINER LH 
  3. REMOVE FRONT SPEED SENSOR LH 
    1. Disconnect the speed sensor connector.
    2. Remove the sensor harness and clamp from the body.
      Fig 1: Connecting Speed Sensor Connector
      G05139751Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 clamp bolts holding the sensor harness and clamp from the body and shock absorber.
      Fig 2: Locating Clamp Bolts
      G05139752Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the bolt and speed sensor front LH.
      NOTE: Keep the tip of the speed sensor front LH.
    5. Fig 3: Locating Front Speed Sensor Bolt LH
      G05139753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.