2009 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE

Front Speed Sensor: Inspection

  1. INSPECT FRONT SPEED SENSOR 
    1. Make sure that there is no looseness at the connector lock part and connecting part of the connector.
    2. Disconnect the speed sensor connector.
    3. Measure the resistance between terminals 1 and 2 of the speed sensor connector.

      OK: 

      Resistance: 

      0.92 to 1.22 kΩ 

    4. Measure the resistance between terminals 1 and 2 of the speed sensor connector and body ground.

      OK: 

      Resistance: 

      1 MΩ or higher 

      Fig 1: Measuring Resistance Between Terminals 1 And 2 Of Speed Sensor Connector
      G05139754Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.