Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE
Freeze Frame Data
- FREEZE FRAME DATA
- Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from OFF to the ON position since the last time the ABS was activated.
HINT:
- Freeze frame data at the time the ABS operates: The skid control ECU stores and updates data whenever the ABS system operates. When the ECU stores data at the time a DTC is detected, the data stored during ABS operation is erased.
- Connect Techstream to the DLC3.
- Turn the ignition switch to the ON position.
- On the tester display, select the Freeze Frame Data.
ABS / VSC / TRAC
FREEZE FRAME DATATester Display Measurement Item Reference Value Freeze DTC Freeze DTC (Trouble code) - Stop Light SW Stop light switch signal Stop light switch ON: ON, OFF: OFF OperatedSYSTEM System status ABS activated: ABS
No system activated: NO SYSNumber of IG ON Number of operations of ignition switch ON after memorizing freeze frame data 0 to 31 Vehicle Speed Vehicle speed reading Min.: 0 mph (0 km/h), Max.: 202 mph (326.4 km/h) Vehicle Speed Grade Vehicle Speed Grade Min.: -1.869 G, Max.: 1.869 G
- Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
