Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009SEQUOIA LIMITED, 5.7 Y, RWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL/DYNAMIC CONTROL SYSTEMFRONT SPEED SENSORINSTALLATION

2009 Toyota Sequoia Limited, 5.7 Y, RWD

Front Speed Sensor: Installation

2009 Toyota Sequoia Limited, 5.7 Y, RWDSECTION Installation

INSTALL FRONT SPEED SENSOR LH
1. Using a hexagon wrench, install the front speed sensor with the bolt.
  Torque: 11 N*m (107 kgf*cm, 8 ft.*lbf)
  NOTE:
  - Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.
  - While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.
  - After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the knuckle.
  - Make sure that there is no foreign matter attached to the magnetic rotor.
2. Connect the front speed sensor connector.
  
  Fig 1: Locating Front Speed Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT WHEEL (See INSTALLATION )
INSPECT SPEED SENSOR SIGNAL (See TEST MODE PROCEDURE )

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.