Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:
*: Use Techstream.
- VEHICLE BROUGHT TO WORKSHOPÂ
- CUSTOMER PROBLEM ANALYSISÂ
- CONNECT TECHSTREAM TO DLC3*Â
HINT:
If the display indicates a communication fault in the tester, inspect the DLC3.
- CHECK DTC AND FREEZE FRAME DATA*Â
HINT:
Record or print DTCs and freeze frame data, if needed.
- CLEAR DTC AND FREEZE FRAME DATA*Â
- VISUAL INSPECTIONÂ
- SETTING CHECK MODE DIAGNOSIS*Â
- PROBLEM SYMPTOM CONFIRMATIONÂ
If the engine does not start, first perform the "CHECK DTC" procedures and "CONDUCT BASIC INSPECTION" procedures below.
MALFUNCTION CHARTMalfunction does not occur A Malfunction occurs B B:Â GO TO STEP Â 10
A: Go To Next StepÂ
- SYMPTOM SIMULATIONÂ
- DTC CHECK*Â TROUBLE CODE REFERENCE CHART
Trouble code A No code B B:Â GO TO STEP Â 12
A: Go To Next StepÂ
- DTC CHARTÂ
NEXT:Â GO TO STEP Â 14
- BASIC INSPECTIONÂ WRONG PARTS REFERENCE
Wrong parts not confirmed A Wrong parts confirmed B B:Â GO TO STEP Â 17
A: Go To Next StepÂ
- PERFORM SYMPTOMS TABLEÂ SYMPTOMS REFERENCE
Wrong circuit confirmed A Wrong parts confirmed B B:Â GO TO STEP Â 17
A: Go To Next StepÂ
- CHECK ECM POWER SOURCE CIRCUITÂ
- CIRCUIT INSPECTIONÂ MALFUNCTION REFERENCE
Malfunction not confirmed A Malfunction confirmed B B:Â GO TO STEP Â 18
A: Go To Next StepÂ
- CHECK FOR INTERMITTENT PROBLEMSÂ
NEXT:Â GO TO STEP Â 18
- PARTS INSPECTIONÂ
- IDENTIFICATION OF PROBLEMÂ
- ADJUSTMENT AND/OR REPAIRÂ
- CONFIRMATION TESTÂ
NEXT: ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
