Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE
Power Steering
- Power Steering System
- Electronic Power Steering System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Calibration
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- DTC Check / Clear
- Freeze Frame Data
- Fail-Safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- DTC C1511: Torque Sensor Circuit Malfunction; DTC C1512: Torque Sensor Circuit Malfunction; DTC C1513: Torque Sensor Circuit Malfunction; DTC C1514: Torque Sensor Power Supply Abnormal; DTC C1517: Torque Hold Abnormal
- DTC C1515: Torque Sensor Zero Point Adjustment Undone
- DTC C1516: Torque Sensor Zero Point Adjustment Incomplete
- DTC C1524: Motor Circuit Malfunction
- DTC C1531: ECU Malfunction; DTC C1532: ECU Malfunction; DTC C1533: ECU Malfunction; DTC C1534: ECU Malfunction
- DTC C1551: IG Power Supply Voltage Malfunction
- DTC C1552: PIG Power Supply Voltage Malfunction; DTC C1554: Power Supply Relay Failure; DTC C1555: Motor Relay Welding Failure
- DTC C1581: Assist Map Number Un-Writing
- DTC U0073: Control Module Communication Bus OFF; DTC U0121: Lost Communication with Anti-lock Brake System (ABS) Control Module
- PS Warning is Always Shown on Multi-Display
- Steering Gear
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
