Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE
Typical Enabling Conditions
Case 1
TYPICAL ENABLING CONDITIONS
| Monitor will run whenever these DTCs are not present | None |
| Engine coolant or intake air temperature at engine start | -8.34°C (17°F) or more |
Case 2
TYPICAL ENABLING CONDITIONS
| Monitor will run whenever these DTCs are not present | P0100 - P0103 (MAF meter) P0110 - P0113 (IAT sensor) P0115 - P0118 (ECT sensor) |
| Engine coolant or intake air temperature at engine start | Between -19.45°C (-3°F) and -8.34°C (17°F) |
Case 3
TYPICAL ENABLING CONDITIONS
| Monitor will run whenever these DTCs are not present | P0100 - P0103 (MAF meter) P0110 - P0113 (IAT sensor) P0115 - P0118 (ECT sensor) |
| Engine coolant or intake air temperature at engine start | Lower than -19.45°C (-3°F) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
