Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Outline
The air conditioning system operates when the SW on the multi-display or the one on the steering wheel is turned on. Turning on the SW sends a signal to A/C control assembly, which activates the air conditioning system.
- Heater Blower OperationÂ
Manual operation
When the blower speed is set to a certain level using the blower control SW, the A/C control assembly sends signals to the blower control to control the blower motor speed.
Auto operation
When the auto SW is pushed, the A/C control assembly calculates the necessary blower speed from the SW settings and data received from the sensors and automatically sends signals to the blower control to control the blower motor speed.
- Air Inlet Control Servo Motor ControlÂ
When the FRESH/RECIRC select SW is set to RECIRC, the air inlet control servo motor starts rotating to move the damper toward the RECIRC side. The damper position is detected by TERMINAL TPI of the A/C control assembly. The motor continuously rotates until the damper reaches its stop position. When the FRESH/RECIRC select SW is set to FRESH, the air inlet control servo motor starts rotating to move the damper toward the FRESH side. The damper position is detected by TERMINAL TPI of the A/C control assembly. The motor continuously rotates until the damper reaches its stop position.
In auto mode, the A/C control assembly controls the damper to move to the best position for the conditions without operating the mode select SW.
- Air Vent Mode Control Servo Motor ControlÂ
When the mode select SW is pushed, the ECU in the A/C control assembly activates the air vent mode control servo motor. The servo motor rotates to the position (FACE, BI-LEVEL, FOOT, FOOT/DEF, DEF) selected by using the mode select SW, and moves the damper.
In auto mode, the A/C control assembly controls the damper to move to the best position for the conditions without operating the mode select SW.
- Air Mix Control Servo Motor ControlÂ
Based on the temperature set on the temperature control SW, the ECU in the A/C control assembly sends a signal to the air mix control servo motor. This signal drives the motor to reach the temperature set by the temperature control SW, and moves the film damper.
- Humidity Sensor ControlÂ
The A/C control assembly detects the humidity in passenger cabin when the A/C is turned on, utilizing the humidity detection function of the A/C room temp. sensor, and if needed begins to dehumidify the cabin to create a comfortable environment.
- Air Conditioning OperationÂ
The A/C control assembly calculates the target cooling temperature from information such as that of operating SWs, room temperature, humidity, ambient temperature and insulation to set the target running speed for the compressor assembly (Motor). The calculated control signal is sent to inverter to drive the compressor assembly (Motor) (Electric motor) and control the inverter, resulting in the A/C operating.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
