Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- PERFORM ACTIVE TEST BY TECHSTREAM (SLIP INDICATOR LIGHT)Â
- Select the ACTIVE TEST, generate a control command, and then check that the SLIP indicator light operates.
ABS / VSC / TRAC:Â
SKID CONTROL ECU DIAGNOSTIC CHARTItem Test Details Diagnostic Note SLIP INDI LIGHT Turns SLIP indicator light ON / OFF Observe combination meter OK:Â
Turn the SLIP indicator light on or off.Â
OK: REPLACE SKID CONTROL ECUÂ
NG: Go to next stepÂ
- Select the ACTIVE TEST, generate a control command, and then check that the SLIP indicator light operates.
- CHECK CAN COMMUNICATION SYSTEMÂ
- Check if a CAN communication system DTC is output (See PROBLEM SYMPTOMS TABLE
)
.
ResultÂ
DTC RESULT REFERENCEResult Proceed to DTC is not output A DTC is output B
B: REPAIR CAN COMMUNICATION SYSTEMÂ
A: Go to next stepÂ
- Check if a CAN communication system DTC is output (See PROBLEM SYMPTOMS TABLE
)
.
- CHECK MULTIPLEX COMMUNICATION SYSTEMÂ
- Check if a multiplex communication system DTC is output (See DTC CHECK / CLEAR
)
.
ResultÂ
DTC RESULT REFERENCEResult Proceed to DTC is not output A DTC is output B
B: REPAIR MULTIPLEX COMMUNICATION SYSTEMÂ
A: REPAIR OR REPLACE COMBINATION METER ASSEMBLYÂ
- Check if a multiplex communication system DTC is output (See DTC CHECK / CLEAR
)
.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
