Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2009 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE

Brake Control Power Supply: Installation

INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET
INSTALL NO. 2 BRAKE CONTROL POWER SUPPLY BRACKET
INSTALL NO. 3 BRAKE CONTROL POWER SUPPLY BRACKET
INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY
1. Install the brake control power supply with the 4 bolts.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
2. Connect the brake control power supply connector.
  
  Fig 1: Installing Brake Control Power Supply Connector With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
1. Install the deck trim side panel RH (See INSTALLATION ) .
  HINT:
  
  Refer to the procedures from the installation of the deck trim side panel assembly RH up until the installation of the rear door scuff plate RH.
INSTALL REAR SEAT CUSHION ASSEMBLY (See INSTALLATION )
CHECK AND CLEAR DTC
1. Check and clear the DTC (see DTC CHECK / CLEAR ).

Chapter Navigation

Return to Chapter: Brake Control Power Supply

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.