2009 Toyota Matrix S, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 4 (Engine Control System (2ZR-FE)): ECM: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ECM 
    1. Install the 2 ECM brackets onto the ECM with the 4 screws.

      Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf) 

      Fig 1: Locating Screws And ECM Brackets
      G06008121Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the ECM with the 3 bolts.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    3. Connect the 2 ECM connectors.
      1. Connect the 2 ECM connectors and lower the 2 levers.
        NOTE:
        • When connecting the connectors, make sure that dirt, water or other foreign matter does not get caught between the connectors and other parts.
        • Make sure that the 2 levers are securely locked.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.