Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Matrix S, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Coolant Temperature Sensor: Inspection
- INSPECT ENGINE COOLANT TEMPERATURE SENSOR
- Measure the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard Resistance
RESISTANCE REFERENCETester Connection Condition Specified Condition 1 - 2 20°C (68°F) 2.32 to 2.59 kΩ 1 - 2 80°C (176°F) 0.310 to 0.326 kΩ NOTE: When checking the engine coolant temperature sensor in water, keep the terminals dry. After checking, wipe the sensor dry.If the resistance is not as specified, replace the engine coolant temperature sensor.
- Measure the resistance.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.