Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Matrix S, AWDFACTORY OEM SERVICE PROCEDURE
Heated Oxygen Sensor: Installation
- INSTALL HEATED OXYGEN SENSOR (for 4WD)
- Using SST, install the heated oxygen sensor.
SST 09224-00010
Torque: without SST
44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST
40 N*m (408 kgf*cm, 30 ft.*lbf)
- Using SST, install the heated oxygen sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.