Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2009 Toyota Matrix S, AWDFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Installation

INSTALL CRANKSHAFT POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
  
  Fig 1: Identifying O-ring Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the crankshaft position sensor with the bolt.
  Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
  
  NOTE: Do not twist the O-ring.
3. Install the wire harness and crankshaft position sensor connector clamp.
4. Connect the crankshaft position sensor connector.
Fig 2: Locating Crankshaft Position Sensor Connector Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL GENERATOR ASSEMBLY (See INSTALLATION )
INSTALL V-RIBBED BELT (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER RH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT FOR OIL LEAK

Chapter Navigation

Return to Chapter: Crankshaft Position Sensor

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.