2009 Toyota Matrix S, AWDFACTORY OEM SERVICE PROCEDURE

Camshaft Oil Control Valve: Installation

  1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY 
    1. Apply a light coat of engine oil to a new O-ring and install it onto the camshaft timing oil control valve assembly.
      Fig 1: Identifying O-Ring Location
      G05183804Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the camshaft timing oil control valve assembly with the bolt.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

    3. Connect the camshaft timing oil control valve connector.
      Fig 2: Locating Camshaft Timing Oil Control Valve Assembly
      G05386895Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the vacuum hose clamp with the bolt.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

  2. INSPECT FOR OIL LEAK 
  3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY  (See INSTALLATION )
Fig 3: Locating Vacuum Hose Clamp Bolt
G05386894Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.