2009 Toyota Matrix Base, StandardFACTORY OEM SERVICE PROCEDURE

Power Outlet Socket: Removal

  1. REMOVE FRONT UPPER CONSOLE BOX  (See REMOVAL )
  2. REMOVE NO. 2 SWITCH HOLE BASE  (See REMOVAL )
  3. REMOVE POWER POINT SOCKET ASSEMBLY 
    1. Disengage the claw and remove the power point socket assembly.
    Fig 1: Identifying Power Point Socket Assembly
    G06037790Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE POWER OUTLET SOCKET COVER 
    1. Disengage the 2 claws and remove the power outlet socket cover.
    Fig 2: Identifying Power Outlet Socket Cover And Claws
    G06037791Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Return to Chapter: Power Outlet Socket
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.