2009 Toyota Matrix Base, StandardFACTORY OEM SERVICE PROCEDURE

Cigarette Lighter: Installation

  1. INSTALL CIGARETTE LIGHTER BEZEL STAY 
    1. Engage the 2 claws to install the cigarette lighter bezel stay.
    Fig 1: Identifying Cigarette Lighter Bezel Stay And Claw
    G06037784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CIGARETTE LIGHTER ASSEMBLY 
    1. Engage the claw to install the cigarette lighter assembly.
    Fig 2: Locating Cigarette Lighter Assembly
    G06037786Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL CIGARETTE LIGHTER BULB 
    1. Install the cigarette lighter bulb.
    Fig 3: Identifying Cigarette Lighter Bulb
    G06037782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL CIGARETTE LIGHTER COVER 
    1. Engage the 2 claws to install the cigarette lighter cover.
  5. INSTALL CIGARETTE LIGHTER KNOB AND ELEMENT ASSEMBLY 
  6. INSTALL NO. 2 SWITCH HOLE BASE  (See INSTALLATION )
  7. INSTALL FRONT UPPER CONSOLE BOX  (See INSTALLATION )
    Fig 4: Identifying Cigarette Lighter Cover And Claws
    G06037781Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Return to Chapter: Cigarette Lighter
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.