Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Technical Service Bulletins
- A/C Compressor
- Accessories & Equipment
- Accessories Control Systems
- GTS+ Ecu Flash Reprogramming Procedure (T-SB-0134-16 REV2)
- Abnormal Power Door Lock Operation (Cycle) (T-SB-0061-13)
- IG1 Relay Freezing (T-SB-0047-09 REV2)
- Remote Engine Starter (Res) Cold Temperature Operation Diagnostic Tips (T-SB-0100-09 (REV 1))
- Audio BLUETOOTH System Outgoing Call Volume Adjustment (T-SB-0097-09)
- Accessory Drive Belts
- Air Bag, SRS
- Anti-Lock Brakes
- Anti-Theft Systems
- Automatic Trans
- Automatic/Continuously Variable Transmission Replacement Precautions (T-SB-0024-18)
- Remanufactured Automatic Transmission Serial Number Location (TC013-06)
- World Standard Automatic Transmission Fluid (TC010-07)
- Automatic Transmission Serial Number Location (TC012-06)
- Special Service Tools (T-SB-0302-08)
- Alignment Pin Installation During Transmission/Transaxle Assembly Installation (T-SB-0053-08)
- Auxiliary Emission Control Systems
- Axle Shafts
- Body Electrical
- Brakes Control Systems
- Charging Systems
- Communication Devices
- Cooling System (Mechanical)
- Engine Control Systems
- GTS+ Ecu Flash Reprogramming Procedure (T-SB-0134-16 REV2)
- Extended Crank At High Altitude With High Temperatures (T-SB-0069-11 REV2)
- Mil "On" P043E, P043F, P2401, P2402, & P2419 Due To Water Intrusion Into Charcoal Canister (T-SB-0200-11 REV1)
- Mil "On" DTC P0456 (T-SB-0165-10 REV1)
- 2AZ-FE & 2AZ-FXE Throttle Body (T-SB-0111-10)
- Mil "On" DTC P2195, P0138, And/Or P0031 (T-SB-0065-10)
- Mil "On" DTC P0456 (T-SB-0175-09 REV1)
- IG1 Relay Freezing (T-SB-0047-09 REV2)
- No Start Or Extended Crank And/Or Mil "On" DTC P030# Or P0015 (T-SB-0182-09)
- 2ZR-FE Engine Oil Consumption (T-SB-0145-08 REV1)
- M.I.L. "On" DTC P0101, P0121, P0171, P0172, P035#, P223# (T-SB-0379-08)
- Entertainment Systems
- Exterior Body Panels
- Frames, Subframes & Crossmembers
- Front Suspension
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing
- Hazardous Waste Material
- HVAC Control Systems
- Identification
- Replacement Certification Labels And VIN Plates (T-SB-0032-20 REV2)
- Replacement VIN Plates (PG009-02)
- Replacement VIN Plates (PG005-97)
- Remanufactured Automatic Transmission Serial Number Location (TC013-06)
- Automatic Transmission Serial Number Location (TC012-06)
- Ca/Fed/50 State Certified Emission Control UNDERHOOD Labels (T-SB-0054-13)
- Engine Serial Number Location (T-SB-0301-08 REV1)
- Replacement Certification Labels And VIN Plates - Crib # 164 (S-CRIB-164)
- Infotainment
- Interior/Exterior Trim
- Prevention And Repair Of Acid Rain Damage (T-SB-091-020)
- Odor Remediation Process (Dealer Performed) (T-SB-0055-24 REV1)
- SUNVISOR - Removal & Installation Procedures (T-SB-0093-09 REV2)
- Water Condensation Dripping From Dome Lamp (T-SB-0344-09 REV1)
- Drivers Front Seat Feels Loose (T-SB-0039-11 REV1)
- Lower B Pillar Garnish Loose (T-SB-0339-09 REV 1)
- Difficulty Closing Glove Box (T-SB-0262-09)
- Floor Mat Installation During PDS (T-SB-0042-08 REV1)
- Floor Mat Installation During PDS (T-SB-0130-08)
- Front Fender Liner Pin Hold Clip Removal/Installation Procedures (T-SB-0073-08)
- Interior/Illumination Lights
- Lubrication System
- Manual Steering
- Mechanical
- Oil Leak Diagnosis And Repair (T-SB-0008-20)
- Torque Converter Bolt Installation (T-SB-0014-11 REV1)
- Hydraulic Versus Mechanical TENSIONERS (TT001-13)
- Brief Engine Knock/Rattle Noise At Cold Startup (T-SB-0087-09 REV2)
- Accessory Drive Belt Noise (T-SB-0136-10)
- 2ZR-FE Engine Oil Consumption (T-SB-0145-08 REV1)
- Special Service Tools (T-SB-0302-08)
- Engine Serial Number Location (T-SB-0301-08 REV1)
- Cylinder Head Cover Baffle Precautions (T-SB-0038-08)
- Mechanical - Hydraulic
- Paint & Coatings
- New Vehicle Washing Schedule For Paint Protection (T-SB-0039-24 REV2)
- Prevention And Repair Of Acid Rain Damage (T-SB-091-020)
- RAPGARD Protective Film Removal (T-SB-0061-23 REV2)
- Iron Particle Rust Contamination Repair (TS-PA005-04)
- PAINTLESS Dent Repair - Crib # 146 (T-CRIB-146)
- Chip Resistant Coatings - Crib # 141 (L-CRIB-141)
- Long Term Vehicle Storage Guidelines (T-SB-0079-09 REV1)
- Plastic Bumper Refinishing - Crib # 170 (L-CRIB-170)
- Permanent-Type Protective Wax Coatings (T-SB-0138-08)
- Passive Restraints
- Procedures
- Rear Suspension
- Restraints Control Systems
- Seats
- Starter
- Steering Column
- Steering Linkage
- Suspension Control Systems
- System
- Extended Crank At High Altitude With High Temperatures (T-SB-0069-11 REV2)
- Mil "On" P043E, P043F, P2401, P2402, & P2419 Due To Water Intrusion Into Charcoal Canister (T-SB-0200-11 REV1)
- Mil "On" P0717 Due To Rodent Damage (2ZR-FE/U341E) (T-SB-0180-11)
- Mil "On" DTC P0456 (T-SB-0165-10 REV1)
- Mil "On" DTC P2195, P0138, And/Or P0031 (T-SB-0065-10)
- Mil "On" DTC P0456 (T-SB-0175-09 REV1)
- No Start Or Extended Crank And/Or Mil "On" DTC P030# Or P0015 (T-SB-0182-09)
- M.I.L. "On" DTC P0101, P0121, P0171, P0172, P035#, P223# (T-SB-0379-08)
- Towing
- Transmission Control Systems
- Wheel Alignment
- Wheels & Tire System
- Tire Repair Resources (T-SB-0187-12 REV2)
- Flood Damaged Vehicle Inspection & Handling (T-SB-0229-12 REV1)
- Tire Positioning Before New Vehicle Delivery (T-SB-0204-10)
- Long Term Vehicle Storage Guidelines (T-SB-0079-09 REV1)
- Tire Inflation Pressure Compensation And Adjustment (T-SB-0345-08 REV2)
- Tire Pressure Monitoring System (TPMS) Tire Registration "Lost Communication With Ecu" (T-SB-0084-09)
- Tire Pressure Warning System Initialization (PD155-07)
- Window Motors & Regulators
- Wiper/Washer Systems
- Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
