2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

General Maintenance

  1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY 
    1. If necessary, tighten the following chassis components.
      • Front axle and suspension
      • Drive train
      • Rear axle and suspension
      • Brake system
      • Engine mounting, etc.
    2. If necessary, tighten the following body components.
      • Seat belt system
      • Seat
      • Doors and hood
      • Body mountings
      • Fuel tank
      • Exhaust pipe system, etc.
  2. REPLACE AIR CONDITIONING FILTER 
    1. Remove the glove compartment assembly.
    2. Remove the filter case from the filter outlet.
    3. Remove the filter from the filter case.
    4. Replace the filter with a new one.
    5. Installation is in the reverse order.
  3. ROAD TEST 
    1. Check the engine and chassis for abnormal noises.
    2. Check that the vehicle does not wander or pull to one side.
    3. Check that the brakes work properly and do not drag.
    4. Settle the parking brake shoes.
  4. BODY INSPECTION 
    1. Check the body exterior for dents, scratches and rust.
    2. Check the underbody for rust and damage. If necessary, replace or repair.
  5. FINAL INSPECTION 
    1. Check the operation of the body parts.
      1. Hood
        • Auxiliary catch operates properly.
        • Hood locks securely when closed.
      2. Front and rear doors
        • Door locks operate properly.
        • Doors close properly.
      3. Back door
        • Door locks operate properly.
      4. Seats
        • Seat adjusts easily and locks securely in all positions.
        • Front seatbacks lock securely in all positions.
        • Folding rear seatbacks lock securely.
      5. Be sure to deliver a clean car. Especially check the following:
        • Steering wheel
        • Shift lever knob
        • All switches and knobs
        • Door handles
        • Seats
Chapter Navigation
Return to Chapter: Body
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.