Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Service Data
BRAKE (FRONT) - SERVICE DATA
| Front brake pad lining thickness | Standard | 12.0 mm (0.472 in.) | |
| Minimum | 1.0 mm (0.0394 in.) | ||
| Front brake disc thickness | for 2ZR-FE | Standard | 22.0 mm (0.866 in.) |
| Minimum | 19.0 mm (0.748 in.) | ||
| for 2AZ-FE | Standard | 28.0 mm (1.102 in.) | |
| Minimum | 25.0 mm (0.984 in.) | ||
| Front brake disc runout | Maximum | 0.05 mm (0.00197 in.) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.