2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft*lbf
Brake actuator x Brake actuator bracket 5.4 55 48 in.*lbf
Brake line x Body 5.4 55 48 in.*lbf
Brake actuator bracket x Body 19 194 14
Brake actuator x Brake line 14 (15) 143 (155) 10 (11)
Front speed sensor x Knuckle 8.5 87 76 in.*lbf
Front speed sensor x Body 8.0 82 71 in.*lbf
Front speed sensor with brake flexible hose x Absorber 29 296 21
Rear speed sensor x Rear axle carrier sub-assembly 8.5 87 75 in.*lbf
Rear speed sensor x Upper control arm assembly 5.0 51 44 in.*lbf
Rear speed sensor x Rear suspension member 8.0 82 71 in.*lbf
Rear speed sensor x Body 8.0 82 71 in.*lbf
Yaw rate and acceleration sensor x Body 20 204 15
Deceleration sensor x Body 20 204 15
Windshield washer jar assembly x Body 5.5 56 49 in.*lbf
Radiator reserve tank assembly x Body 7.0 71 62 in.*lbf
() without union nut wrench
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.