2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Check Mode Procedure

WARNING: This page is about a different variant/trim than selected.

HINT:

Techstream:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected in normal mode.

NOTE: All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and note any DTCs and freeze frame data.
  1. CHECK MODE PROCEDURE 
    1. Check and ensure the following conditions:
      1. Battery voltage 11 V or more.
      2. Throttle valve fully closed.
      3. Transmission in the P or N (neutral) position.
      4. A/C switch OFF.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
    7. Switch the ECM from normal mode to check mode.
    8. Make sure the MIL flashes as shown in the illustration.
    9. Start the engine.
    10. Make sure the MIL turns OFF.
    11. Simulate the conditions of the malfunction described by the customer.
    12. Check DTCs and freeze frame data using the Techstream.
    Fig 1: Driving Pattern Of MIL Flashes
    G04828037Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Return to Chapter: SFI System
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.