2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Audio And Visual System: Precaution: Precaution

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE 
    NOTE:

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

    System Name See Procedure
    Power Window Control System Refer to INITIALIZATION
    Sliding Roof System
  2. EXPRESSIONS OF IGNITION SWITCH 
    1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this service information.
      Switch Type Ignition Switch
      (Position)
      Engine Switch
      (Condition)
      Expression Ignition Switch off LOCK Off
      Ignition Switch ON ON On (IG)
      Ignition Switch ACC ACC On (ACC)
      Engine Start START Start
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.