Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Pressure Regulator: Installation
- INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
- Apply gasoline to 2 new O-rings and then install them to the fuel pressure regulator assembly.
- Install the fuel pressure regulator assembly.
- INSTALL FUEL PUMP (See INSTALLATION )
- INSTALL FUEL SENDER GAUGE ASSEMBLY (See INSTALLATION )
- INSTALL FUEL SUCTION TUBE ASSEMBLY
- Install the fuel suction tube assembly to the fuel tank assembly (See INSTALLATION ).
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.