Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

INSTALL THROTTLE BODY ASSEMBLY
1. Install a new gasket onto the intake manifold.
  
  Fig 1: Locating Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle body assembly with the 2 bolts and 2 nuts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Locating Bolts And Nuts And Throttle Body Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 2 water by-pass hoses and the throttle body connector.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE
1. Install the air cleaner cap sub-assembly with hose with the 2 clamps.
  
  Fig 3: Locating Throttle Body Connector And Water By-Pass Hoses
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tighten the hose clamp to the specified torque.
  Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf)
  
  Fig 4: Locating Hose Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the ventilation hose.
  
  Fig 5: Locating Ventilation Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the wire harness clamp and mass air flow meter connector.
ADD ENGINE COOLANT (See COOLANT )
INSPECT FOR COOLANT LEAK (See COOLING SYSTEM )
INSTALL NO. 2 CYLINDER HEAD COVER (See INSTALLATION )
PERFORM INITIALIZATION
NOTE: Perform the following procedure after replacing the ECM, throttle body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.