2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

HINT:

  • DTC P2610 is set if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is necessary.
  • Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.
  1. REPLACE ECM 
    1. Replace the ECM (See REMOVAL ).
  2. CHECK WHETHER DTC OUTPUT RECURS (DTC P2610) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Clear DTCs (See DTC CHECK / CLEAR ).
    5. Switch the ECM from normal mode to check mode.
    6. Start the engine and wait for 10 minutes or more.
    7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    8. If no pending DTC is displayed, the repair has been successfully completed.

      NEXT: END 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.