Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Air Fuel Ratio Sensor: Installation
- INSTALL AIR FUEL RATIO SENSOR
- Using SST, install the air fuel ratio sensor.
SST 09224-00010
Torque: without SST
44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST
40 N*m (408 kgf*cm, 30 ft.*lbf)
NOTE:- This torque value is effective when SST is parallel to the torque wrench.
- This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and SST with a measurement of 30 mm (1.18 in.) (See REPAIR INSTRUCTION ).
- Using SST, install the air fuel ratio sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.