2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Cigarette Lighter: Removal

  1. REMOVE FRONT UPPER CONSOLE BOX  (See REMOVAL )
  2. REMOVE NO. 2 SWITCH HOLE BASE  (See REMOVAL )
  3. REMOVE CIGARETTE LIGHTER KNOB AND ELEMENT ASSEMBLY 
  4. REMOVE CIGARETTE LIGHTER COVER 
    1. Disengage the 2 claws and remove the cigarette lighter cover.
    Fig 1: Identifying Cigarette Lighter Cover And Claws
    G06037781Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE CIGARETTE LIGHTER BULB 
    1. Remove the cigarette lighter bulb.
    Fig 2: Identifying Cigarette Lighter Bulb
    G06037782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE CIGARETTE LIGHTER ASSEMBLY 
    1. Disengage the claw and remove the cigarette lighter assembly.
    Fig 3: Locating Cigarette Lighter Assembly And Claw
    G06037783Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE CIGARETTE LIGHTER BEZEL STAY 
    1. Disengage the 2 claws and remove the cigarette lighter bezel stay.
    Fig 4: Identifying Cigarette Lighter Bezel Stay
    G06037784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Return to Chapter: Cigarette Lighter
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.