Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Outline
- Speed SensorÂ
Detects the speed of each of the four wheels.
- Brake Actuator AssemblyÂ
Based on signals from the sensors, it judges the vehicle driving condition and sends brake control signals to the brake actuator.
- ABS Warning LightÂ
Lights up to alert the driver when the ECU detects a malfunction in the ABS system and stops the system.
- Brake Warning LightÂ
Lights up simultaneously with the ABS warning light to alert the driver when the ECU detects a malfunction not only in the ABS but also in the EBD. Lights up by itself to alert the driver when the ECU has detected a malfunction in the brake system.
- Engine Control ComputerÂ
Sends the throttle valve opening angle, crank position sensor, etc., to the brake actuator assembly.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
