DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT WHEEL RH
REMOVE GENERATOR ASSEMBLY (for 2ZR-FE)
HINT:

Refer to the instructions for Removal of the generator assembly (See REMOVAL ).
REMOVE GENERATOR ASSEMBLY (for 2AZ-FE)
HINT:

Refer to the instructions for Removal of the generator assembly (See REMOVAL ).
DRAIN BRAKE FLUID
NOTE: If brake fluid leaks onto any painted surface, immediately wash it off.
REMOVE RADIATOR RESERVE TANK SUB-ASSEMBLY
1. Remove the 3 bolts and radiator reserve tank sub-assembly.
REMOVE FRONT BUMPER ASSEMBLY
HINT:

Refer to the instructions for Removal of the front bumper assembly (See REMOVAL ).

Fig 1: Locating Radiator Reserve Tank Sub-Assembly Mounting Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE WINDSHIELD WASHER JAR ASSEMBLY
1. Remove the bolt and clamp and disconnect the motor connectors.
2. Separate the washer hoses from the windshield washer jar assembly.
  
  Fig 2: Locating Washer Hoses And Motor Connectors Bolt And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 2 bolts, clamp and the windshield washer jar assembly from the body.
  
  Fig 3: Locating Windshield Washer Jar Assembly Bolt And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BRAKE ACTUATOR WITH BRACKET
1. Release the lock lever and disconnect the brake actuator connector.
  NOTE: Be careful not to allow brake fluid to enter the removed connector.

Chapter Navigation

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

BRAKE ACTUATOR (w/ VSC): Removal