2009 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Brake Control / Dynamic Control Systems: SST

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS - SST

G06039799Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
09214-76011 Crankshaft Pulley Replacer  
G06039800Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
09520-00031 Rear Axle Shaft Puller  
G06039801Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
(09520-00040) Shocker  
G06039802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
(09521-00010) Rod with Grip  
G06039803Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
09521-00020 Drive Shaft Boot Clamping Tool  
G06039804Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
09843-18040 Diagnosis Check Wire No. 2  
G06039805Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
09950-00020 Bearing Remover  
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.