Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota FJ Cruiser RWDFACTORY OEM SERVICE PROCEDURE
Service Data
FUEL - SERVICE DATA SPECIFICATION
| Fuel pressure | 281 to 287 kPa (2.87 to 2.93 kgf*cm2 , 40.8 to 41.7 psi) | ||
|---|---|---|---|
| Fuel pressure | 147 kPa (1.5 kgf*cm2 , 21 psi) or more | ||
| Fuel injector | Resistance | at 20Β°C (68Β°F) | 11.6 to 12.4 Ξ©. |
| Injection volume | 76 to 91 cm2 (4.6 to 5.5 cu in.) per 15 seconds | ||
| Difference between each cylinder | 15 cm3 (0.9 cu in.) or less | ||
| Fuel leakage | 1 drop or less every 12 minutes | ||
| Fuel pump resister | Resistance | at 20Β°C (68Β°F) | 0.941 to 0.999 Ξ©. |
| Fuel Pump | Resistance | at 20Β°C (68Β°F) | 0.2 to 3.0 Ξ© |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.